Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
I smacked my heater box pretty good when installing the 401 into my '88 GW. Irvin hooked me up with a metal heater box in Las Cruces and I'm planning...
My fuel and water temp gauges are not working. Every once in awhile the water temp gauge will shoot up to red, but then come right back down to below...
Last post
Fuel gauge:
As a test, run a wire from the sending unit to the negative post of the battery, to see if you have a ground problem.
Was going to order some new front floor panels here soon from BJ's, however i see where ZM has them for $20 cheaper. Anyone have any opinion either...
Last post
alright im getting closer to ordering...decided im gonna go with z&m. found these two part numbers. they are apparently both complete sides and they...
So, I wasn't sure where a good spot to put this question would be. My fuel filler hose is leaking when I'm putting gas in the tank. Like, almost a...
Last post
If you get the same year Wagoneer hose, it'll be the same. Same chassis/frame and same body with the exception of the tail lights and flares. And of...
Any reason (other than cost) to not use synthetic oil in axles? None of my rigs have any type of 'limited...
Last post
Synthetic will clean out some of the old crud built up inside old dino systems. That's why the small leaks possible when switching over. I decided to...
Like with every other project undertaken with this Jeep, axles are an unknown frontier for me. The closed knuckle 44 will be getting discs and I have...
Last post
I found replacement outer lock nuts with set screws at scoutparts.com. They look the same and I think the spindles should be the same so these should...
My power steering pulley was apparently un-detachable from the old pump that died, so mine is now shot. I located the replacement pulley on BJ's/TGW,...
Last post
got a new pump and ended up picking up a pulley from BJ's along with a new cap. works great
Anyone have an exploded view for the Vacuum Disconnect Dana 44 handy? I am trying to determine which seal I need to get. The drivers side (Side with...
Last post
Thanks for the link Jeff!!! I was able to find the exploded view I was looking for. From the exploded view, it appears as though there is a bearing...
I'm about ready to start re-assembling the axles and frame. So it's time I get serious about springs. I want a stock ride height and so the question...
Last post
New springs are fine unless they are abused hard offroad.
Personally even if I wanted stock, I would go with 2 springs. May not Sean like much, but...
I need to locate the proper bushing to go in the TOP of the shackle, where it mounts to the frame....
Last post
has listing for it. I've never worked with them but I heard if you call them they're helpful. Or if you can figure out their site it lists product#s...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
