hi,
i m upgrading a delco distributor but i m not sure it is ok.
First : the gap is close to 0.010 a lowest and just under 0.060 a the greatest which a huge variation between module and magnet ring, is it normal ???
Second : there is a drill mark on gear and it is supposed to be aligned with rotor tip, but when i installed a new rotor i noticed that the mark was at the opposite location, so is it normal ? i have removed the gear and reinstall with mark aligned but not sure if it is correct...
thanks
Tara
IMG_1918 by Simon Hiquily, sur Flickr
IMG_1919 by Simon Hiquily, sur Flickr
IMG_1921 by Simon Hiquily, sur Flickr