Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Ok so I just started fabbing up my trans/belly skid plate. Anyone have any pictures or ideas of what they have done? Still in the cardboard stages so its not to late to change my design if needed.
89 GW- Rebuilt 360 w RV camshaft, 4 inch Rustys spring lift, 1" body lift, dana 44HD front, 14 bolt rear 3.73's.
78 Cherokee Chief- work in progress
Allow room to access the bolts for WHEN you bend the plate. Give tanks, etc a couple inches breathing room. Also, if you plan to go into mud, you want holes to wash it out so the frame doesn't rot (like the later models)
88 Grand Wagoneer - The Money Pit - 360/727/NP208 - SOA/SF - Lots of other stuff SOLD
78 Cherokee Chief - Copper - 360/TH400/Quadratrac - 4 inch BDS lift - 33 inch tires SOLD
88 Grand Wagoneer - The Money Pit - 360/727/NP208 - SOA/SF - Lots of other stuff SOLD
78 Cherokee Chief - Copper - 360/TH400/Quadratrac - 4 inch BDS lift - 33 inch tires SOLD
Heh i like that one too! I had to make version 2.0 after that one since i somehow lost it, or it was stolen. Only used stiffeners at the front and back and so far no issues.
J20 brett.....great looking skid. Very close to what I'll be making. I will have a solid crossmember behind the T-case to support it too. The rear crossmember will be there to mount the shackle to my track bar.
89 GW- Rebuilt 360 w RV camshaft, 4 inch Rustys spring lift, 1" body lift, dana 44HD front, 14 bolt rear 3.73's.
78 Cherokee Chief- work in progress