Dana 20 rear output, yoke nut, where to get?

[J7M46sn]

I need a new rear yoke nut on my Dana 20 transfer case. I have used the original one, to tighten and loosen so many times, checking end play of the bearings in there, I think the nut is worn out.

It appears to be a 3/4"-16 UNF thread size, but it might be a special thread? It's definitely 3/4" OD threaded shaft...

Where can I get one of these?

[tgreese]

IIRC it's supposed to be a single-use item. Use once, discard.

Any of the Jeep retailers will have it. Jeep PN 801367. Your local parts store should be able to get it too. Lots of sources.

https://www.bing.com/search?q=Jeep+801367

RockAuto has it for 59c each, but you have to buy 25. https://www.rockauto.com/en/parts/dana, ... +nut,11629 They show a Dana part number - you could search for that or ask at the parts store.

Suggest you learn to look up stuff like this yourself. The '62-73 and '81-85 parts books are free to read and download on the Tom Collins site. The '74-80 book can be bought for under $25 on CD-ROM from RockAuto and elsewhere. Transfer case is group 18. Find the part, get the Jeep PN and search online. Not difficult.

One might use blue Loctite for the interim.