Page 1 of 1
Dash Install
Posted: Fri Nov 16, 2018 6:58 am
by 1977ChiefLS3
Does anyone know the correct product for the black 'goo' on segments of the windshield frame to dash mounting?
Is that just 3M seam sealer in strips? Non-hardening weather strip?
Sent from my SM-G965U using Tapatalk
Re: Dash Install
Posted: Fri Nov 16, 2018 4:00 pm
by FLeetFox
I was planning on using this:
https://www.eastwood.com/ew-flexible-st ... 2-lbs.html
or an equivalent 3m product.
Fleet Fox
Re: Dash Install
Posted: Sat Nov 17, 2018 8:51 am
by tgreese
I have not taken a dash out, but in my experience everywhere Jeep mated two sheet metal parts together, they put butyl strip caulk between. No squeaks or rattles! You can buy the stuff specific to cars, but AFAIK it's no different from Mortite or such that you can buy at the home center.
https://www.amazon.com/Thermwell-Mortit ... nkCode=df0
Re: Dash Install
Posted: Wed Nov 21, 2018 11:01 am
by letank
I used the above product, indeed it stays flexible after many, many years, it is a sticky modeling clay, you can make a small ball for fill area that are a bit too large, and it is paintable.
Re: Dash Install
Posted: Wed Nov 21, 2018 7:22 pm
by 1977ChiefLS3
Thanks for the input. I've got some of the 3M seam sealer in stick form and appears to be essentially what all of you used.