Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
1980 Jeep Cherokee 2 Door. Amc 360 engine. T176 4 speed transmission. 4 wheel drive. Factory a/c set up. New MSD hei cap, rotor, and plug wires. New spark plugs. New MSD epoxy filled coil. Mr. Gasket distributor springs. New distributor rectifier. Rebuilt motorcraft carb. New battery. New air filter. New clutch. New transmission oil. Have a new oil filter and oil to do oil change. Replaced a lot of the rubber hoses so far. New belts. New rear main seal. New oil pan gasket.
Runs and drives but fuel pump went out. Have 2 new mechanical fuel pumps. Also have electric frame mount fuel pump and oil pressure sensor to upgrade to. Have 1 1/2 new rebuild kits for carb. Transmission does not like going into fourth gear, but works fine in other gears. Have new valve cover gasket set. Needs new shocks. Tires hold air.
Will need to be trailered. Would like $2500 for it. Will get some pictures soon. Will update post as I remember things.
Ohhhhh I wish I wish I wish.......
If I had the money, time, and my wife was ok with it..........(salivating all over this thing), I would be there in a minute and bring it home!
'81 CJ5 Base, 258 I6, MC2100, T176 4 spd, 300 TC, D30 Front NT, 3.31, 2-Piece AMC 20 rear NT, 3.31, 4" high arc spring lift
'84 Grand Wagoneer, 401 V8 (.030 over), Edelbrock clone 1406, 727 auto, Selec-trac NP229, AMC 20 REAR - D44 FRONT - WT 3.31, 4" high arc spring lift
Rather be driving, than waiting to be modified
Could post over here too for free on Jeep Forum.
Might need to sign up, and respond to others posts to get your membership validated, then you can post to Classifieds......I think.
Id pick that up for my Off Road project if you weren't so far away! Id turn it into a Uni-body pickup, run 1 Ton axles, Rocklaurence Long Travel suspension and cut the fenders for 40's.
I am 100% interested. Had a '78 before I was transferred overseas a few years ago. I can't figure how to PM you. Will try to figure that out for a few more minutes then will just put my email here.