Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
I made a mistake and I'm looking for solutions. I installed a used 727 from a 1990 GW into my 1984 GW. I was not aware that the flex plate/starters...
Last post
Yeah, don't let your fear of the wiring diagrams convince you to pull the transmission again. Suggest you get your colored pencils, paper and eraser...
Did these transmissions not have magnets in the pan lol.
Doing full fluid oil changes on my 76 J1p.. and the transmission pan has no magnet ? Thats...
Last post
The magnet was only in the 4 inch deep pan which wasn't available when Jeep bought these transmissions. Not sure what all vehicles had them, but I'm...
So im working on my J10s 360. It drives good.. and no smoke at all and no knocks or sny noise.. it sounds better than my 90 granted it has 80k miles...
Last post
Same issue, burning oil on startup... pulled the plug and got an oily #6 -that is after 200 miles-
I have a 1977 Cherokee Chief with a 360 and motorcraft 4bbl 4350.
It’s been sitting for a while so I pulled the carb and did a quick clean and...
Last post
Hey guys…thanks for the reply’s. I have a TSM for 1977. This Cherokee is bone stock…with everything as it was from the factory. I bought it from the...
I am in need of a new transmission mount. I looked a few different places and seems that what gets pictured is a different style depending on who the...
Last post
so mostly right I as far as swaps go.I am in the process of replacing the torque arm bracket (which was missing) and replacing a badly worn and...
I am in need of a new transmission mount. I looked a few different places and seems that what gets pictured is a different style depending on who the...
So messing with my J10 replacing. The pligs. Wires. Checking compression.. I had it idling in the shop for 10 minutes.. and noticed smoking coming up...
Last post
I found it was a lose battery cable causing it. These terminals suck they squeeze up the post and become lose so that positive cabke was just...
It's finally time to throw these emblems back on. I don't love the idea of drilling holes. My plan was to cut the pins off and use 3m emblem tape but...
Last post
I have the JEEP V8 369 fender emblems on my 9p gw. I just cut the pins.. and glued em with 3m emblem tape. Its held fir like 5 years now
Has anyone successfully done a conversion from the old tape-style tracks on the Grand Wagnoneer (84 - 89)?
The replacement cable-style regulators...
Last post
I looked at this solution, especially after installing a new tape, it broke right away when testing -at least I had an extra spare- the OE from Mopar...
I need to replace both the input and output seals. I have seen the procedure of blowing out the output seal but don't want to run the risk of a mess...
Last post
Hey, long time no see, hope all is well.
When I did the pitman arm seal on my '75 I used two ice picks that had 90 degree tips on the end. Its been...
Ok so hear me out. This is the least of my priorities.. but its one im unsure of. When messing with the underside i grabbed the exhaust pipe on the...
Last post
Stuka is right, soak with penetrating oil. weld a nut on and heat the manifold ear with the stud in it with an oxy fuel torch. when the heat is right...
After getting a few things in order to make my jeep run and drive, it seems to be stuck in one gear. I think it's stuck in 2nd gear because going...
Last post
The reason for asking was that I had a similar issue... whatever I did, fluid up to specs... I rechecked the TV linkage and something was off... the...
So now that my J10s cabin and bed is done being rebuilt. Im focusing on getting it running. At least to test drive it around the back roads.. before...
Last post
So i got it running.. runs great. But the flap on the carb doesnt open fully when warmed up. It jiat stays mostly closed
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
