Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
The hard lines going to and from the transmission cooler were kinked due to bad motor and transmission mounts before my son bought his Wagoneer. Can...
Last post
There are brass adapter fittings the brake lines will screw into. IIRC it's 5/16 lines for 727 and 3/8 for TH400.
Hi y'all. Hope you can help me. I have this 77 Honcho with 360 and T18 tranny. It sat since 2005 and I want to bring it back to life. When I hit the...
Last post
parts stores carry shims made for Ford starters, but they only push the starter away from the flywheel.
Does anyone know where to find new Defroster Hoses for my 1978 Cherokee Chief?
Or any times on how to repair .. mine seem to only have the wire...
Last post
I had replaced mine last winter with a plastic w/ metal ribs I got from a local auto parts store. Harder than heck to install but should last longer...
Cherry won't start
Drove it home today,got in garage popped hood to check float Level due to bad bogging on take off.removed air horn did the job,out...
Last post
Got the new coil in checked everything again.fired up.side note:I rebuilt my 2150 and it was running like crap,bog on take off,rough idle etc.so I...
Strange things are happening... I'm in socal, it's currently 70 and sunny (sorry to some of you). Yesterday I pulled into my driveway after driving...
Last post
tgreese, no worries. I put the old 180 back in with a new gasket and no rtv, operating temp is back to where it was so were good there. The choke on...
So I went out this morning turned the key to on and everything was fine turned it to start and everything went dead. No amount of jiggling helps and...
Last post
I just had this same problem. Started and ran fine on the way to work. 1 hour later, go to start it and click, nothing. I found that I still had 12...
Hello I am looking for a replacement fuel tank for my 1980 J20 which is split (plastic). I have tried to repair unfortunately this only lasts a week...
I want to upgrade my stock PS pump/pulley system. Any ideas on what I can use that would be cost effective and have parts that would be available? I...
Last post
I remember paying $30 for a brand new PS pump pulley at a Jeep dealer in the 90s. I bet if you had been here with a post in the wanted section,...
Hi Guys, I've been posting about my 81 J10 build over on jeepfourum but they don't seem too excited. So I thought I'd check you guys out.
I'll...
Last post
In working through this on the Cherokee build I ran across the same problem I decided to go Stainless steel for obvious reasons. I found a reasonably...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
