Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
My ammeter is holding around +30 while driving. It only occasionally drops back around 0 or slightly negative. It's a new battery, and I suspect the...
Last post
Time to change that voltage regulator, it ought to be on the firewall or fender, '75 is too early to have the VR in the alternator, unless it was...
Back in my dealership days we had plenty of 'Experienced' FSJs come in for this issue. The lock mechanism would get sloppy and the door would lock...
Last post
The spring breaks and flies away. Boeing surplus had a 45 gallon barrel full of them about 10 years ago. Wish I had bought more. Temporarily you can...
I need inner and outer door glass seals for all 4 doors. Do I need to buy them specifically for a 79 wag, or will pretty much any wagoner seals work?...
Last post
One more thing... I'm going to replace the valve cover gaskets, do you know the torque specs for the 360? I think its 50 in lbs but I'm not sure....
I have managed to get the Jeep going, at least it will start and idle pretty well, started dismantling the instrument panel, lots of pack rat damage...
Last post
You could also try model glue made for model windows. It's not supposed to ruin the plastic if you get it where it shouldn't be. I've never tried it...
I'm having some trouble with my drivers side window. As I was rolling up my window, the window just stopped and slid down on its own...
Last post
I have the door panel off on the jeep and took a look at the window lift and measured.
I can confirm that the lifter channel and loop are the same as...
I have a ticking noise under my valve cover and im suspecting the rocker arm bridges, i was wondering if the stock gaskets are reusable if i pull the...
Bought new door seals from BJ's for the 81 J10 and now the doors wont close ,already tried Adjusting the door but still a no go, its like the seals...
Last post
I am going to try to relieve the corners since the rubber seems to bunch up making it harder compress. The plan is to make several perpendicular cuts...
Can you all weigh in on how hard it would be to convert some power window doors to the old manual window crank type? Any help/prior experience would...
Last post
Going to start this very thing this weekend. I will post back my findings.
Tried to get the truck started yesterday, found the entire steering column ignition switch, locking mechanism, key switch and everything else in the...
Last post
Got it, it runs, now just have to sort out the fuel system and redo the exhaust. I'll drop the tank tomorrow and find out why fuel runs out on the...
The cruise control on my '88 GW surges at all speeds when engaged. The speed remains constant, but you can feel/hear the engine RPM cycle. As far as...
Can anyone weigh in on wether to stick with the stock exhaust manifolds or go with an aftermarket header? Any pros or cons to either set up? Any do's...
Last post
As a lifelong hot-rodder, racer and mechanic...who has gotten old and practical I suggest you stay with factory cast iron manifolds unless you are...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
