Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Installed a Holley 600 CFM this summer, and now with the mornings getting colder it's time to set the choke. I'm assuming for it to open more slowly...
Last post
TBI will come:) just gotta wait on a few things til the wife gets done with school :geek:
Anyone run the Offy Dual Port intake? I am looking at the one that has split intake runners for each port.
Last post
I ran it on a 6 cyl and discovered that if I wanted more top end, I had to reverse the carb. I also built a plate to change the angle of the airflow...
Ok..i have a very demented and fragmented mind. lol Barely 1/4 of the way done with the SOA install and my mind is already on to the next part of the...
Last post
I am looking at both of those as well. Probably part of my procrastination to get Schwag put back together. That, and I spent yesterday going to N Ga...
I probably should have taken some pics, but there really isn't much to take pics of...
Installed some Stage 8 locking spindle nuts on the front of...
Last post
Stephen over at ORD seemed to think a lot of them. He even said that he no longer carries a spindle nut socket when he 'wheels ever since he started...
Since IFSJA is down and searching cached Google results is not helping, I will ask live here.
I was given an Edelbrock 2131 Performer intake...
Last post
I ended up using a Fel-pro MS-96001 valley pan set. We sealed the ports, used the end seals, and built up sealant in the corners near the end seals....
So I'm gathering parts to upgrade my brakes. Vac booster from an 89 vintage Wag and last week I picked up a new MC for an 89 as well. Looking at the...
Last post
I decided hydroboost brake upgrade a long time ago. Especially after having a 5 ton truck with a ripper from a D9 cat on the back stall on a 10%...
I dropped the tank and fuel lines today looking for problems. This was installed in Spring of 1999 after I drilled a hole in the side of the poly...
Last post
BTW, the AZ pump is pushing 3 psi compared to the NAPA 8 psi unit that does not get the job done. Haven't had time to go to Durango NAPA yet. The GW...
Years back found that the front/rear covers are different on the 44's
The front is 10 gauge verse the rear at 14 gauge.
The fill hole is 1 1/4 inches...
Last post
Well, it used to be pretty.
I set my D60 guard up a little different since the stock tie rod comes very close to the diff cover at full turn.
This...
I adjusted my timing a bit and got it tuned in. I did this with the engine warmed up and I removed the vacuum advance like the book says. Took it for...
Last post
Correct answer Stuka........You answered my question right after I figured it out. :ymblushing:
She's truly running like a champ now. I was hold the...
Getting ready to start my track bar on my chief. The front axle is a 2006 ford d60 with radius arms. I know the track bar and steering drag link need...
Last post
Thanks
I have some poly bushings laying around so I think I'll try them. Make one end fixed and the other adjustable.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum