Page 1 of 1
Which/ where do these wires go?
Posted: Sat Jan 18, 2014 3:15 pm
by RanchGX
So I got caught up in replacing broken wires on my rig, and halfway through realized that I didn't label all of the. FML
So I need some assistance.
Where exactly the posts on the starter relay go to? Bal, I, G dont help me.....
Also the wire diagram says that a green ignition wire goes to the positive battery terminal on the solenoid. Is that the one the is the solid green wire out of the ignition box, or something else?
Im using the diagrams from here:
http://oljeep.com/gw/elec/GW_wiring-1990.html
What does it mean when the diagram says "See SH 5" I've been looking all over and cant find any SH references. It's driving me insane.
Re: Which/ where do these wires go?
Posted: Sat Jan 18, 2014 5:24 pm
by chevelleguy
You should put your vehicle in your signature line so we know what your working on.
Re: Which/ where do these wires go?
Posted: Sat Jan 18, 2014 5:49 pm
by RanchGX
1988 grand wagoner
Re: Which/ where do these wires go?
Posted: Sat Jan 18, 2014 8:00 pm
by Racegas
I believe that SH 5 refers to that sheet number of the entire diagram.
Re: Which/ where do these wires go?
Posted: Sun Jan 19, 2014 5:20 am
by jaber
Here is the pinout for the relay...
http://oljeep.com/gw/elec/90_numeric/90 ... lenoid.jpg
In the bottom corner of each page there is an SJ#, and it corresponds with the SH#s, so sh7 is page sj7. I pulled both pages up and verified.
Re: Which/ where do these wires go?
Posted: Sun Jan 19, 2014 11:12 pm
by RanchGX
Only problem with that diagram is that it is missing the BAL listed on it. I know something goes there, just cant remember what.
Re: Which/ where do these wires go?
Posted: Mon Jan 20, 2014 6:02 am
by jaber
I believe its the wire to the starter.
Re: Which/ where do these wires go?
Posted: Mon Jan 20, 2014 8:43 am
by csuengr
Black wire that goes to the starter goes on SOL terminal, along with the wire to the ignition coil. Ground goes to NSS wire. Start signal wire goes to I terminal
Re: Which/ where do these wires go?
Posted: Wed Jan 22, 2014 1:13 pm
by RanchGX
csuengr wrote:Black wire that goes to the starter goes on SOL terminal, along with the wire to the ignition coil. Ground goes to NSS wire. Start signal wire goes to I terminal
So BAL does not get used then correct?
Re: Which/ where do these wires go?
Posted: Wed Jan 22, 2014 1:44 pm
by csuengr
I've never seen that terminal before. Just let us know if you have an extra wire in that area.
Re: Which/ where do these wires go?
Posted: Wed Jan 22, 2014 2:04 pm
by rocklaurence
Could it be for the ignition coil ballast resistor? A resistive wire used in the run mode?
Re: Which/ where do these wires go?
Posted: Fri Jan 31, 2014 8:28 pm
by GonOvr
Not sure if you figured this out or not but here...
