Sniper / Hyperspark Install - 82 Cherk

For everything related to using Fuel Injection in an FSJ.
Post Reply

Topic author
ArchitectJS
Posts: 293
Joined: Thu Oct 15, 2015 5:01 pm

Sniper / Hyperspark Install - 82 Cherk

Post by ArchitectJS »

A couple of questions;

I have the EFI mounted and plumbed in. Linkages connected.

I plan on swapping the distributor next.

Anybody have any recommendations on locating the ignition module and coil?
  • Over at the Holley board they talk about proximity and interference. I didn't see too much about that in the instructions. Perhaps I need to re-read
  • I was thinking about how best to lay things out so that my wiring is neat and clean. The PO left a mess with regard to original wiring
  • My TSM stops at the wiring diagram section. I plan on removing anything that touched an old ignition component. Is this safe to say? Is there something i should watch out for?
Thanks for your replies.
1982 Cherokee, base (Bumppo)
AMC 258 / A727 - AMC 20 / NP208
Holley Sniper with Hyperspark
3" Rough County Lift
Post Reply