Page 1 of 1
Converting 86/91 control panel
Posted: Sun Jul 12, 2020 8:06 am
by sonoraed
Original hvac control panel 86/91 FSJ,
Because Vintage Air uses cable converters to control temp and function ( dash air /defrost/ floor) we need at least two levers , so going to cut the top off the back side of head
Blower is controlled by original indak switch
Sent from my iPhone using Tapatalk
Re: Converting 86/91 control panel
Posted: Sun Jul 12, 2020 8:14 am
by sonoraed
The new top piece is from sacrificed second panel, just screwed together and install cable converters
I believe the control panel were also used in newer Jeep Cherokee’s
Kit to control vintage air gen IV magnum is for a 1966 Pontiac GTO, did this 6 years ago so would need to check if kit is still designed to work with indak blower switch
Sent from my iPhone using Tapatalk
Re: Converting 86/91 control panel
Posted: Sun Jul 12, 2020 8:19 am
by sonoraed
Tight fit but works with no problems
Sent from my iPhone using Tapatalk
Re: Converting 86/91 control panel
Posted: Tue Jul 14, 2020 6:13 am
by sonoraed
Vintage Air no longer make a control panel kit that uses the standard 5 prong Indak blower switch, all signals to the GenIV module use VA cable controllers, may be able to still use the 66 GTO control panel kit, but I have not done so at this time.