Well, I installed the carb using the default settings and it ran okay, but had a rough idle. At higher RPM'S it would run good, but I didn't have a fuel source hooked up yet (Running off a Jerry can on the ground.
I think part of the issue was due to under-fueling caused by the fuel source being so much lower than the mechanical pump, as it seemed like the fuel filter would never get totally full.
I have since installed a new Polyurethane tank from BJ's, along with a pull through electric fuel pump for priming.
Got a couple of things to finish up, but should be able to fire her up within the next week or so.
Sent from my Pixel 4a (5G) using Tapatalk