Full Size Jeep Network

A couple of questions;

I have the EFI mounted and plumbed in. Linkages connected.

I plan on swapping the distributor next.

Anybody have any recommendations on locating the ignition module and coil?

• Over at the Holley board they talk about proximity and interference. I didn't see too much about that in the instructions. Perhaps I need to re-read

• I was thinking about how best to lay things out so that my wiring is neat and clean. The PO left a mess with regard to original wiring

• My TSM stops at the wiring diagram section. I plan on removing anything that touched an old ignition component. Is this safe to say? Is there something i should watch out for?

Thanks for your replies.