Full Size Jeep Network

The springs from BJs did the trick for keeping my lock knobs up. However, the rod clips were all but destroyed when I got in there and the rattle is getting on my nerves. Does anyone know of a source for new or NOS lock rod clips / guides?

Collar Diameter: approx 15mm
Insert Diameter: approx 10mm
Internal/Rod Diameter: approx 4mm

This or something similar may work https://www.ebay.com/itm/67-69-Camaro-F ... SwIIJdRvua

Those appear to be for the knobs at the top of the lock rod. Without any measurements to go off of, I would venture to guess those are far too big for my purposes.

Those appear to be for the knobs at the top of the lock rod. Without any measurements to go off of, I would venture to guess those are far too big for my purposes.

Flanged plastic sleeve bearing is similar.
https://www.mcmaster.com/bushings/beari ... -bearings/

If you knew a machinist, I believe the parts could be easily made.

Thank you for the suggestions. The plastic/nylon clips I'm referring to are inside the door and guide the rod, not the knob. The plastic clips themselves snap into a semicircle piece of metal, see attached photos, and are held in place by "teeth" on the underside of the clip. See the below link for a good example.

http://www.spendlessautoparts.com/retai ... mi908.html

All of the clips that I have found online are too small. Either the teeth won't clip the metal, or the shoulder would fall right through.