J10 Bed
Posted: Thu Apr 20, 2023 3:49 pm
I am selling a j10 short bed for a later j10. The outside is currently in epoxy primer, because I made patch panels to fix the bed seams. 
For the most part it is a pretty good bed, but in the front right corner on the inside, it has a hole where the roll bar used to sit and the inner bedside also has a large hole in it. For a driver this would be an ok bed, and it would be a great bed for an offroad toy, or use for patches for a different bed. Above the wheel opening it was rusty and I didn’t make a patch for it, we just used metal reinforced body filler on it because we knew I wasn’t going to use the bed. I am asking $400 obo.
Sent from my iPhone using Tapatalk
For the most part it is a pretty good bed, but in the front right corner on the inside, it has a hole where the roll bar used to sit and the inner bedside also has a large hole in it. For a driver this would be an ok bed, and it would be a great bed for an offroad toy, or use for patches for a different bed. Above the wheel opening it was rusty and I didn’t make a patch for it, we just used metal reinforced body filler on it because we knew I wasn’t going to use the bed. I am asking $400 obo.
Sent from my iPhone using Tapatalk