Camo-ed head liner, use high temp spray glue to adhere to liner board, cut out for lights
Bubble wrap insulation ,25’x4’ roll, don’t use near generated high heat (next to exhaust,interior roof lights)
Leave edge clear 3/4”+-, so liner board can fit back into track
My arm rests ,most of em ,had screw pass way broken
Used 3/8 tube lined it up with pin pushed through to keep alinement glued in place put broken parts in to fill space when glued
I tried expanding foaming glue on other holes ,ok also,
Leave for cure time before use
Nice new,stainless bolt nylon nut for spare tire
Spare rim ,cleaned,painted back side black epoxy paint front white epoxy.
Ahhh some more fun, while doing things noticed hose was crooked , unscrewed you see results, too many threads. Very surprised it hadn’t leaked.
Good tool,may use it once not much call for it but,when ya need it , ya need it. Cleaned up nice, new hose went right in.
New motor mounts, so much easier w nose clip off.
Sent from my iPad using Tapatalk