Put in a new fuel tank, with in tank pump. So had to run high pressure line to fuel rail. It's returnless(I think), so I used one of those corvette filters/regulators.
(New tank is bjs, in tank pump is bjs, fuel lines were rockauto stock replacement but I’m only gonna use one of them. I’m gonna do the evap delete.
When that’s sorted, I’ll need to route the lines and shorten them. Mount filter to frame rail.
But the big one, filler hoses were just dead and splitting. So I got some from a hose shop. Gonna route them, mount the tank and install.
Main filler line: 1” ID
Vent filler line: 3/4” ID
Vent that goes into the rear quarter panel: 3/4” ID
Exhaust looks like it'll need to be done at a shop. It's pretty tight.
Tank is on driver, but transfer case front drive line is passenger. So I'll have to have them custom made to snug past that. And run back on pass side
Sent from my iPhone using Tapatalk