So my front driveshaft was twisted in half by the PO at some point years ago.
I'm trying to get the last two bolts out of the back of it, open end wrench style, but it's spinning. So I shove a pry bar up there to hold it still, but wrench keeps slipping off.
Concerned about rounding the bolts off, but theres no room to get a normal socket or closed end on it.
Wondering if a thin wall socket might fit, but can't seem to find a good source for a 3/8 drive thinwall socket.
Anyone know where to find one?
Sent from my LM-T600 using Tapatalk